AddThis

Bookmark and Share

Saturday, 25 January 2014

Hall Effect Sensor based non-contact tachometer for electrical motors speed measurement


       The purpose of this project is to design and construct a non-contact type of Tachometer. A tachometer(also called a revolution-counter, rev-counter, or RPM gauge) is an instrument that measures the rotation speed of a shaft or disk, as in a motor or other machine. Hall Effect sensors typically use a rotating target attached to a wheel, gearbox or motor. This target may contain magnets, or it may be a toothed wheel. The teeth on the wheel vary the flux density of a magnet inside the sensor head.

        This project consists of a Hall effect sensor connected to a microcontroller unit. The sensor signals from Hall effect sensor are sent to microcontroller for rpm measurement. These measured final values arc displayed on a LCD display connected to microcontroller.





2 comments:

  1. very informative post for me as I am always looking for new content that can help me and my knowledge grow better.

    ReplyDelete
  2. That is an extremely smartly written article. I will be sure to bookmark it and return to learn extra of your useful information. Thank you for the post. I will certainly return.

    ReplyDelete

There was an error in this gadget